TM 10-3510-220-24
2-31.
EXTRACTOR DRIVE BELT (CONT)
d. If drivebelt (4) is too right, remove two or three flat washers from behind spring (3).
e. Position motor hanger (1) and swing tension bolt (2) with spring (3) into slot of hanger. Ensure
drivebelt (4) stays in correct position.
NOTE
A new drivebelt will usually eliminate slipping without an adjustment for tension.
f. Slide belt guard (5), back into position and secure with screw (7) and lockwasher (6).
REPAIR
NOTE
Repair at this level consists only of drivebelt replacement and adjustment.
1. Remove drive belt (4) as follows:
a. Remove screw (7) and lockwasher (6) and slide belt guard (5) away from machine.
b. Pull motor hanger (1) away from machine and relieve tension on spring (3). Swing tension
bolt (2) and spring (3) away from motor hanger.
c. Remove drivebelt (4).
2. Install new drive belt (4) as follows:
a.
b .
c.
d .
Install drive belt (4) incorrect position.
Position motor handler (1) and spring tension bolt (2) with spring (3) into slot of hanger.
Check for proper belt tracking and tension.
Slide belt guard (5) back into position and secure with lockwasher (6) and screw (7).
3. Perform follow-on installation.
Install work platform in transport position (TM 10-3510-220-10).
2-99
