TM 10-3510-220-24
2-30. EXTRACTOR DRIVE UNIT
This task covers:
a. Service
b. Removal
c. Installation
INITIAL SETUP
Equipment Condition
Tools
TM 10-3510-220-10, Extractor empty.
General mechanic’s tool kit
General Safety Instructions
Personnel Required
WARNING
Three
High voltage is present on this equipment.
Do not perform maintenance with power
on. Death or serious injury may result.
SERVICE
WARNING
High voltage is present on this
equipment. Do not perform
maintenance with power on.
Death or serious injury may result.
N O T E
Servicing of drive unit consists of
checking oil level or addin oil to
the turbine clutch.
1. Remove two screws (1) and flat washers (2) and remove access plate (3).
2. Rotate extractor basket (4) until oil level/fill plug (5) is visible. Remove plug. Oil level
should be even with bottom of hole when extractor is on a level surface.
3. Refer to LO 10-3510-220-12 for turbine oil instructions.
4. Replace oil level/fill plug (5). Install access plate (3) and secure with two flat washers (2)
and screws (1).
2-95
