TM 10-3510-222-24
3-29. CONTROL CONSOLE - continued.
(5)
Latch (39) and strike (36).
(a)
Strike (36).
(1)
Remove two screws (34) and lockwashers (35).
(2)
Remove strike (36).
(3)
Position new strike (36) on washer control console (3) and install two lockwashers (35) and
screws (34).
(b)
Latch (39).
(1)
Remove two screws (37) and lockwashers (38).
(2)
Remove latch (39).
(3)
Position new latch (39) on control console (3) and install two lockwashers (38) and screws
(37).
c.
INSTALLATION
(1)
Position four washers (29) on control stand (30).
(2)
Position washer control console (3) on control stand (30).
(3)
Install four flat washers (28), lockwashers (27) and nuts (26).
NOTE
Wire numbers are stamped on each electrical wire. This information, in conjunction with data on
FO-2 Washer Wiring Diagram, may be used to connect wires if tags are lost or illegible.
(4)
Install (door lock) new seal (24), 90° connector (25), nut (23) and electrical wiring as tagged.
(5)
Install (level sensor) new seal (21), connector (22), nut (20) and electrical wiring as tagged.
(6)
Install (motor) new seal (18), connector (19), nut (17) and electrical wiring as tagged.
(7)
Install (power in) new seal (15), power connector (16), nut (14) and electrical wiring as tagged.
(8)
Install new seal (12), connector (13) and nut (11).
(9)
Install hose (9) on pressure switch (10).
(10)
Install air hose (7) on adapter (8).
(11)
Install air hose (5) on adapter (6).
(12)
Install five air hoses (4) on washer control console (3).
(13)
Install cover (2) with twelve screws (1) on washer control console (3).
3-64