TM 10-3510-222-24
3-30. CONTROL PANEL.
This task covers:
a.
Removal
b.
Repair
c.
Installation
INITIAL SETUP
Tools
General Mechanics Tool Kit (App B, Item 1)
Trailer Mounted Welding Shop
(App B, Item 8)
Materials/Parts
Adhesive (RTV) (App D, Item 1)
Tags (App D, Item 4)
Equipment Condition
Laundry Unit shut down (TM 10-3510-222-10)
General Safety Instructions
WARNING
High
voltage
is
present
on
this
equipment. Do not perform maintenance
with power on. Death or serious injury
may result.
a.
REMOVAL
(1)
Remove twelve screws (1) from cover (2) and remove cover (2).
(2)
Tag and disconnect wiring from control panel (3).
(3)
Remove adhesive (RTV) from around control panel (3).
(4)
Remove four screws (4) and washers (5).
(5)
Remove control panel (3).
b.
REPAIR
(1)
MASTER ON/OFF, AUTO/MANUAL, DRAIN OPEN/CLOSED, LEVEL SELECT 1 and 2, COLD
WATER ON/OFF, HOT WATER ON/OFF switches (7) and SIGNAL CANCEL switch (8).
(a)
Remove twelve screws (1) from cover (2) and remove cover (2).
(b)
Tag and remove electrical wiring to switch (7 or 8) being replaced.
(c)
Remove boot (6) from switch (7 or 8) and remove switch (7 or 8).
(d)
Position new switch (7 or 8) on control panel (3) and install boot (6).
NOTE
Wire numbers are stamped on each electrical wire. This information, in conjunction with data on
FO-2 Washer Wiring Diagram, may be used to connect wires if tags are lost or illegible.
(e)
Connect electrical wiring as tagged.
(f)
Position cover (2) on control panel box and install twelve screws (1).
(2)
SIGNAL CANCEL (9).
(a)
Remove twelve screws (1) from cover (2) and remove cover (2).
(b)
Tag and remove electrical wiring from SIGNAL CANCEL (9).
3-65
