TM 10-3510-222-24
3-30. CONTROL PANEL - continued.
(c)
Remove SIGNAL CANCEL cover (10) from SIGNAL CANCEL (9) and remove SIGNAL CANCEL
(9).
(d)
Position new SIGNAL CANCEL (9) on control panel (3) and install cover (10).
NOTE
Wire numbers are stamped on each electrical wire. This information, in conjunction with data on
FO-2 Washer Wiring Diagram, may be used to connect wires if tags are lost or illegible.
(e)
Connect electrical wiring as tagged.
(f)
Position cover (2) on control panel box and install twelve screws (1).
(3)
LEVEL LOW/1 or HIGH/2 (17).
(a)
Remove twelve screws (1) from cover (2) and remove cover (2).
(b)
Tag and remove electrical wiring from switch (17).
(c)
Loosen setscrew (11) and remove knob (12).
(d)
Remove nut (13) from switch (17) and remove switch (17).
(e)
Position new switch (17) on control panel (3) and install nut (13).
(f)
Position knob (12) on switch (17) and tighten setscrew (11).
NOTE
Wire numbers are stamped on each electrical wire. This information, in conjunction with data on
FO-2 Washer Wiring Diagram, may be used to connect wires if tags are lost or illegible.
(g)
Connect electrical wiring as tagged.
(h)
Position cover (2) on control panel box and install twelve screws (1).
(4)
ON, SUPPLIES, TIMER Light(s) (14).
(a)
Remove twelve screws (1) from cover (2) and remove cover (2).
(b)
Tag and remove electrical wiring from light (14).
(c)
Remove light (14).
(d)
Remove clip (15).
(e)
Install clip (15) on new light (14).
(f)
Install light (14) in control panel (3).
NOTE
Wire numbers are stamped on each electrical wire. This information, in conjunction with data on
FO-2 Washer Wiring Diagram, may be used to connect wires if tags are lost or illegible.
(g)
Connect electrical wiring as tagged.
(h)
Position cover (2) on control panel box and install twelve screws (1).
3-68
