TM 10-3510-222-24
3-32. CHASSIS CONTROL - continued.
(f)
Position cover (4) on control console (8) and install twelve screws (3).
(8) Reversing Contactor (30).
(a) Remove twelve screws (3) from cover (4) and remove cover (4).
(b) Tag and disconnect electrical wiring to reversing contactor (30).
(c) Remove reversing contactor (30).
(d) Install new reversing contactor (30).
NOTE
Wire numbers are stamped on each electrical wire. This information, in conjunction with data on
FO-2 Washer Wiring Diagram, may be used to connect wires if tags are lost or illegible
(e) Connect electrical wiring to reversing contactor (30) as tagged.
(f)
Position cover (4) on control console (8) and install twelve screws (3).
c. INSTALLATION
(1) Install four bolts (2) and nuts (10) on chassis control (9)
(2) Apply RTV around bolts (2) on the control console (8).
(3) Position chassis control (9), flat washers (7) on control console (8) and install flat washers (6) and nuts (5).
NOTE
Wire numbers are stamped on each electrical wire. This information, in conjunction with data on FO-2
Washer Wiring Diagram, may be used to connect wires if tags are lost or illegible
(4) Connect electrical wiring to chassis control (9).
(5) Install pressure switch and control console (Para 3-29).
3-77
