OIL HOUSING- continued

TM-10-3510-222-24
Page Navigation
324

TM 10-3510-222-24 3-48. OIL HOUSING- continued d. ADJUSTMENT CAUTION Incorrect gap will damage drive unit. NOTE Adjustment consists of checking/obtaining correct gap between runner and clutch driver and requires that brake assembly is installed on unit (1) Remove fill plug (1). CAUTION If oil is spilled, drain oil and replace 40 ounces of lubricant. Too much or too little oil will result in damage to drive unit. (2) Use feeler gage thru fill hole and measure gap between runner (26) and clutch driver (25). Gap should be 0.088 to 0.092 inch. (3) If gap is less than 0.088 or greater than 0.092, proceed as follows: (a) Remove rubber shaft seal (37). (b) Loosen three setscrews on shaft nut (38) and two setscrews on hub (39). (c) Loosen or tighten shaft nut (38). Tighten nut to widen gap and loosen nut and strike shaft with plastic hammer to make gap smaller. (e) Measure gap to see if it changed. Adjust again, if necessary. (f) When gap is correct, turn nut (38) a maximum of 1/6 a turn either way to align any setscrew hole with flat on shaft. Install a setscrew in this hole and tighten. (g) Install additional setscrews in any of the five additional holes to prevent loss of screws. (h) Tighten two setscrews on hub (39). (i) Install rubber shaft seal (37). (4) Install fill plug (1). 3-114

Privacy Statement
Press Release
Contact