TM 10-3510-222-24
3-48. OIL HOUSING.
This task covers:
a.
Disassembly
b.
Repair
c.
Assembly
d.
Adjustment
INITIAL SETUP
Tools
General Mechanics Tool Kit (App B, Item 1)
Automobile Vehicle Shop Equipment
(App B, Item 3)
Drain Pan (App B, Item 16)
Materials/Parts
Lubricant (App D, Item 18)
Equipment Condition
Laundry Unit shut down (TM 10-3510-222-10)
Drive Assembly removed (Para 3-46)
Brake removed (Para 3-47)
a.
DISASSEMBLY
(1)
Remove plug (1) and drain oil from unit.
(2)
Remove screw (2), lockwasher (3) and flat washer (4).
(3)
Remove three screws (5) on pulley (6).
(4)
Thread screws (5) into holes on hub (7) to loosen hub.
(5)
Remove hub (7) and key (8).
(6)
Remove six screws (9), lockwashers (10) and cover (11).
(7)
Remove retaining ring (12) and bearing (13) from cover (11).
(8)
Remove six screws (14) and lockwashers (15).
(9)
Remove drive housing (16).
(10)
Remove sixteen screws (17) and lockwashers (18).
(11)
Remove lower housing (19). As required, remove any additional oil left in housing.
(12)
Remove packing (20), six screws (24) and clutch drive (25) from lower housing (19).
NOTE
If bushing is defective, discard bushing and lower housing.
(13)
As required, drill out bushing (21) from lower housing (19).
(14)
Remove nut (22), lockwasher (23), runner (26), key (27) and upper housing (28) from shaft (36).
(15)
Remove bushing (29) from upper housing (28).
(16)
Remove four screws (30), lockwashers (31) and bearing retainer (32).
(17)
Remove bearing (34) from housing (35).
(18)
Remove bearing seal (33) from bearing retainer (32).
3-111
