TM 10-3510-222-24
3-78. DRYER CONDUITS - continued.
(2)
Transformer Box - Control Box Conduit.
(a)
Tag wires (2) connected to terminals 3 and 4 at scanner terminal box (3), loosen screws (1) and
remove wires (2).
(b)
Tag wires (5) connected to terminals T1, T2 and T3 at motor starter (6). Remove screws (4) and
remove wires (5).
(c)
Tag wires (8) connected to terminals NR (wire #40), CG (wire #30) and TR3 (wire #29) at terminal
board (9). Remove screws (7) and disconnect wires (8).
(d)
Remove nut (10) and pull adapter (11) with attached parts out of control box (14).
(e)
As required, remove gasket (12) from adapter (11).
(f)
Remove conduit (13) from transformer box (Para 2-56).
Figure 3-78. Transformer Box - Control Conduit Removal
3-184
