TM 10-3510-222-24
3-79. DRYER BASE.
This task covers:
a.
Removal
b.
Repair
c.
Installation
INITIAL SETUP
Tools
General Mechanics Tool Kit (App B, Item 1)
Automotive Vehicle Shop Equipment (App B,
Item 3)
Installation Fastener Tool (App B, Item 9)
Materials /Parts
Adhesive (App D, Item 23)
Rivet, Blind (App C, Item 39)
Rivet, Blind (App C, Item 14)
Screw, Captive (App C, Item 40)
Rivet, Solid (App C, Item 43)
Nut, Blind (App C, Item 44)
Nut, Blind (App C, Item 45)
Nut, Blind (App C, Item 46)
Nut Blind (App C, Item 47)
Equipment Condition
Dryer Cylinder removed (Para 3-77)
Cover (ON/OFF Switch) removed (Para 3-63)
Electrical components removed (Paras 3-63
thru 3-70)
a.
REMOVAL
(1)
Remove five rivets (1).
(2)
Support control box cover (2) and loosen three captive screws (12) from base (17).
(3)
As required, remove five rivets (3) and separate hinge (4) from base (17).
(4)
Remove rivet (5).
(5)
Remove door (9) and gasket (6). As required, remove rivet (7) and chain (8) from door (9).
(6)
Remove two solid rivets (10).
(7)
As required, remove insulation sheet (11).
(8)
As required, remove three captive screws (12) from control box cover (2). Discard captive screws (12).
(9)
As required, remove blind nuts (13, 14, 15 and 16).
(10)
Remove eleven nuts (18), sixteen lockwashers (19), flat washers (20) and screws (21).
(11)
Remove base (17).
b.
REPAIR
Repair consists of replacing damaged and/or missing components of the dryer base.
c.
INSTALLATION
(1)
Install base ( 17), secure with eleven nuts (18), sixteen lockwashers (19), flat washers (20) and screws (21).
(2)
If removed, install blind nuts (13,14,15 and 16) on base (17).
3-187
