TM 10-3510-224-13&P
0008 00
Procedure 2: Water Leak
INITIAL SETUP:
Equipment Condition
CSSL set-up, but not in operation
Materials/Parts
None
Maintenance Level
Operator
IS WATER LEAKING FROM WASHERS ?
HAND-TIGHTEN WATER HOSES AT REAR
OF WASHERS. CLOSE BALL VALVE ON
SUPPLY LINE OF ANY WASHER THAT
CONTINUES TO LEAK AFTER HAND-
TIGHTENING HOSES. DISCONTINUE USE
OF LEAKING WASHERS AND NOTIFY
UNIT MAINTENANCE.
IS WATER LEAKING FROM INTERNAL
FRESHWATER LINE?
CHECK BALL VALVE AT END OF
INTERNAL WATER LINE. CLOSE VALVES
AS NECESSARY. IF THE LINE IS LEAKING
DUE TO DAMAGE, SHUT DOWN CSSL
(REFER TO WORK PACKAGE 0005) AND
NOTIFY UNIT MAINTENANCE.
IS WATER LEAKING FROM
WASTEWATER LINE ?
CHECK WASTEWATER LINE AND
INDIVIDUAL WASHER WASTEWATER
HOSES. TIGHTEN HOSE FITTINGS AS
NECESSARY. IF THE LINE IS LEAKING
DUE TO DAMAGE, SHUT DOWN CSSL
(REFER TO WORK PACKAGE 0005) AND
NOTIFY UNIT MAINTENANCE.
CHECK INTEGRITY OF THE CARGO
CONTAINER, PARTICULARLY AROUND THE
DOORS TO DETERMINE IF THE CAUSE OF
THE LEAK IS OTHER THAN THE SYSTEM
COMPONENT OR IF THE WATER IS
COMING IN FROM OUTSIDE. NOTIFY UNIT
MAINTENANCE IF LEAK CONTINUES.
NO
YES
YES
YES
NO
NO
END OF WORK PACKAGE
0008 00-3/(4 Blank)
