TM 10-7360-226-13&P
0006 00
CONTAINERIZED KITCHEN (WITH TRAILER)
OPERATION UNDER USUAL CONDITIONS
6. Secure the remaining serving door. Fold the bottom of the door inward and push it under the
door so it will not be caught when the wing is closed.
7. Remove the locking pins attaching the three wing jacks to the wing, and remove the jacks. It
may be necessary to crank the wing up slightly to take the weight off the pins before they can
be removed.
WARNING
When raising or lowering the wings, one member of the crew must act as a
spotter to ensure that all personnel stay clear.
8. Winch up the wing using the right winch. When the wing is approximately halfway up, stop
winching. Push in on the fabric at each end of the wing so it will properly fold up as the wing is
closed.
9. Continue winching up the wing. When it is nearly closed, climb onto the container and attach
the orange safety strap. After the strap is attached, unlock and rotate the four cam-locks on
the side of the wing 90o so their handles are pointing straight outward.
10. Continue winching up the wing until it is almost closed and the winch becomes hard to turn.
The spotter can advise the person operating the winch when the wing is almost closed.
11. Partially engage the four cam-locks by rotating their handles approximately 45o toward their
locked position. Crank the wing closed a few more turns, then completely engage and lock the
cam-locks.
12. Return the jack/winch handle to its storage location on the side of the rifle rack. Strap it in
place with its handle end up.
13. Pack the three pairs of stair railings upside down just inside the personnel door. Strap the
railings in place on both sides of the door using two short rubber straps.
14. On the Main Control Panel, turn the INTERIOR LIGHTING and EMERGENCY LIGHT switches
OFF.
15. Close and latch the personnel door.
Jack Removal
If they were used, remove the corner jacks and screw jacks as follows.
1. Lower the corner jacks until the end of the container is resting on the ground. Remove the
jacks.
2. Install the corner jacks at the opposite end of the container. Raise the end of the container just
until the weight is off of the screw jacks. Remove the screw jacks.
3. Lower the corner jacks until the end of the container is resting on the ground. Remove the
jacks.
Change 2
0006 00-34
