TM 10-7360-226-13&P
0006 00
CONTAINERIZED KITCHEN (WITH TRAILER)
OPERATION UNDER USUAL CONDITIONS
ratchet from being trapped between the two cabinets and damaging them during transit).
Tighten the strap securely.
4. Place the second storage cabinet next to the first, with its front facing the cook center. Strap it
down with one ratchet strap run from side to side. Tighten the strap securely.
Hand Sink Assembly
1. Tightly coil the internal drain hose and pack it in the back of the sink assembly.
2. Tightly coil the water supply hose and connect its ends together to prevent contamination.
Tightly coil the external drain hose. Pack both hoses on the lower shelf of the sink assembly.
3. Unplug the water heater and water pump power cables from the appliance control box, coil
them, and stow them in the back of the sink base. Unplug the appliance control box, coil its
cord, and stow it in the sink base assembly.
4. Locate the sink assembly as shown earlier in Figure 15, with its front to the side of the mobile
warming cabinet, and strap it down with one ratchet strap run from side to side. Tighten the
strap securely.
Food Preparation Wing Closure
1. Close and secure the windows in the food preparation wing.
2. Retrieve any ratchet straps and rubber straps still hanging in the food preparation wing and
place them in a convenient location in the serving wing.
3. Retrieve the empty arch component storage bags.
WARNING
A storage bag filled with shelter arch components weighs approximately
130 lbs (59 kg). Three persons must carry the bag, lifting with legs, not
back, to prevent injury.
4. Remove the adjustable spacer. Starting in the middle of the wing, remove the arch spacers
and arch frame assemblies (it may be necessary for personnel to push up on the fabric while
removing the assemblies). Disassemble the components and place them in one of the storage
bags. Temporarily move the bag to the serving wing so it is out of the way.
5. If still running, turn off the ECU and then shut down the generator from the generator control
panel.
6. Remove the locking pins attaching the three wing jacks to the wing, and remove the jacks. It
may be necessary to retrieve a winch handle and crank the wing up slightly to take the weight
off the pins before they can be removed.
7. If installed, remove the platform rail, platform, and stair/ladder at the personnel door and
temporarily set them out of the way (the platform will interfere with the winch handle).
WARNING
When raising or lowering the wings, one member of the crew must act as a
spotter to ensure that all personnel stay clear.
8. If not already done, retrieve a jack/winch handle from its storage location on the side of the rifle
rack.
Change 2
0006 00-32
