TM 10-3510-209-24
3-16. EXTRACTOR ASSEMBLY (CONT)
REPAIR (Cont)
f.
Remove two allen-head screws (35), washers
(36), and solenoid shield (37).
g.
Tag and disconnect wires (38) on brake solenoid
(39).
h.
Straighten and remove cotter pin (40), three
spacers (41), and connector link (42) from brake
solenoid (39).
i.
With a multimeter on the low ohms scale,
measure across the brake solenoid (39).
Multimeter should indicate approximately 12.5
ohms.
j.
Remove four screws (43) and brake solenoid
(39).
k.
Install new brake solenoid (39) and secure with
four screws (43).
l.
Install connector link (42) on new brake solenoid
(39), and secure with three spacers (41) and
cotter pin (40). Bend end of cotter pin.
m.
Connect wires (38) to brake solenoid (39).
Remove tags.
n.
Install solenoid shield (37) and secure with two
allen-head screws (35) and washers (36).
o.
Refer to paragraph 2-28 and adjust the brake.
p.
Refer to REPAIR, step 11, and install curb on
base.
3-64
