TM 10-3510-209-24
3-16. EXTRACTOR ASSEMBLY (CONT)
REPAIR (Cont)
c.
Remove gyro ball cap (44) from the top of
gyro ball (45).
d.
Install new gyro ball cap (44) on gyro ball
(45) and tap into place with plastic mallet.
If the ball cap does not easily fit in place,
soak it in warm water for a few minutes.
e.
Lubricate gyro ball (45). Refer to
LO 10-3510-209-12.
f.
Install extractor basket and lower lid to
operating position. (Refer to step 2q
above.)
5.
Remove and replace gyro ball (45).
WARNING
High voltage is present on this
equipment.
Do
not
perform
maintenance with power on. Death
or serious injury may result.
a.
Remove ball cap (44) from the top of gyro
ball (45). (Refer to step 4 above.)
b.
Use a block of wood and a hammer and
remove gyro ball (45) from the shaft.
Place the block under the gyro ball and
drive the ball from the shaft.
3-66
