TM 10-3510-209-24
3-18. EXTRACTOR CONTROL BOX (CONT)
ADJUSTMENT (Cont)
d.
Adjust lid hinge brake adjusting bolt (4), located on the center of hinge brake (5), for proper lid tension.
e.
Install extractor control panel cover (3), twelve lockwashers (2), and screws (1).
WARNING
High voltage is present on this
equipment.
Do
not
perform
maintenance with power on. Death
or serious injury may result.
WARNING
Failure to properly adjust the lid
safety switch could result in injury to
personnel.
2.
Adjust lid safety switch (9).
a.
Set extractor circuit breaker on electrical
panel to the OFF position.
b.
Remove twelve screws (1), lockwashers
(2), and extractor control panel cover((3)
from rear of unit.
c.
Ensure lid (6) is closed.
d.
Use allen wrench and loosen lid safety
cam screw (7).
e.
Rotate lid safety cam (8) until lid safety
switch (9) is pressed.
3-77
