TM 10-3510-220-24
2-46.
DRYER FUEL PUMP ASSEMBLY (CONT)
ASSEMBLY
1.
2.
3.
4.
5.
6.
7.
8.
9.
Install bleed valve (40) in
fuel pump body (21).
Install pressure adjusting
screw (24) in end plug assembly
(25).
Install spring (28), spring seat
(27), gasket (26), end plug (25),
gasket (23), and acorn nut (22)
on fuel pump body (21).
Install sleeve (35), O-ring (36),
sleeve retainer (37), gasket (38)
and end plug (39) on fuel pump
body (21).
Install gasket (20) and port
housing (19).
Install shaft assembly (29) and
then install seal (30), seal
washer (31), seal spring (32),
seal cup (33), and seal cap
(34).
Install spacer plate assembly
(18) and end plate assembly
(17) and secure with five
screws (16).
Install strainer (14) and
anti-hum wafer (15).
Install gasket (13) and cover
(12) and secure with eight
capscrews (11).
2-166
