TM 10-3510-220-24
2-46.
DRYER FUEL PUMP ASSEMBLY (CONT)
INSTALLATION
1.
Install fuel pump (8) on air intake
housing (10) and secure with two
bolts (7) and lockwashers (9).
NOTE
The fuel pump shaft must be
aligned with the fuel pump impeller
coupling before assembling the air
intake and blower housings.
2.
Install tee (5), with pressure gage (6)
and drain valve (1) attached, on fuel
pump (8).
3.
Uncap and install input fuel line (2),
output fuel line (3), and fuel return
line (4).
4.
Return the fuel line caps to the storage
bins.
5.
Close fuel drain valve (1).
6.
Adjust fuel pump pressure.
ADJUSTMENT
NOTE
Power must be applied to the dryer, and the dryer and fuel pump must be operating before
fuel pump pressure can be adjusted.
1.
Remove acorn nut (22) from pressure adjusting screw (23).
2.
Turn pressure adjusting screw (23) to adjust pressure gauge (6). (Refer to paragraph 2-44, Adjustment 3b).
3.
Install acorn nut (22) on pressure adjusting screw (23).
4.
Perform follow-on installation.
Install tarp assembly (TM 10-3510-220-10).
Change 4
2-167