TM 10-3510-220-24
2-46. DRYER FUEL PUMP ASSEMBLY (CONT)
DISASSEMBLY (Cont)
4.
5.
6.
7.
8.
Remove seal cap (34), seal cup
(33), seal spring (32), seal washer
(31), and seal (30). Remove shaft
assembly (29).
Remove end plug (39), gasket (38),
sleeve retainer (37), O-ring (36) and
sleeve (35) from fuel pump body
(21).
Remove acorn nut (22), gasket (23),
end plug (25), gasket (26), spring
seat (27) and spring (28) from fuel
pump body (21).
Remove pressure adjusting screw
(24) from end plug assembly (25).
Remove bleed valve (40) from fuel
pump body (21).
REPAIR
1. Inspect all parts for wear and damage.
2. Use replacement kit to replace parts that are damaged, defective, or excessively worn. If
replacement of parts is not practical, replace pump.
SERVICE
WARNING
Drycleaning solvent P-D-680 is toxic and flammable. Wear protective
goggles and gloves and use only in a well-ventilated area. Avoid
contact with skin, eyes, and clothes and don’t breathe vapors. Do not
use near open flame or excessive heat. Do not use near open flame or
excessive heat. The flash point is 100 - 138°F (38 - 59oC). If you become
dizzy while using cleaning solvent, get fresh air immediately and get
medical aid. If contact with eyes is made, wash your eyes with water
and get medical aid immediately.
Clean strainer (14) with drycleaning solvent (Item 10, App C) and dry thoroughly.
2-165
