TM 10-3510-220-24
2-46. DRYER FUEL PUMP ASSEMBLY (CONT)
REMOVAL (Cont)
3. Open fuel drain valve (1) and relieve fuel
pressure. Close the valve.
WARNING
Failure to cap disconnected fuel lines could
result in fuel being siphoned onto the ground
and equipment.
4. Remove input fuel line (2) from the fuel filter.
5. Remove output fuel line (3) and fuel return
line (4). Install line cap in return line.
6. Remove tee (5) with pressure gage (6) and
drain valve (1) attached.
7.
1.
2.
3.
Remove two bolts (7), lockwashers (9)
and fuel pump (8) from air intake housing
(10).
D I S S E M B L Y
Remove eight capscrews (11), cover
(12), and gasket (13).
Remove strainer (14) and anti-hum
wafer (15).
Remove five screws (16), end plate
assembly (17), spacer plate
assembly (18), port housing (19)
and gasket (20).
2-164