TM 10-3510-220-24
2-47.
DRYER FUEL FILTER ASSEMBLY (CONT)
REPAIR (Cont)
4.
5.
6.
7.
WARNING
Drycleaning solvent P-D-680 is toxic and
flammable. Wear protective goggles and
gloves and use only in a well-ventilated
area. Avoid contact with skin, eyes, and
clothes and don’t breathe vapors. Do not
use near open flame or excessive heat.
The flash point is 100 - 138°F (38 - 59°C).
If you become dizzy while using cleaning
solvent, get fresh air immediately and get
medical aid. If contact with eyes is made,
wash your eyes with water and get
medical aid immediately.
Clean all parts in drycleaning solvent.
Install two preformed packings (14),
nipple (13), and handle (12) on fuel
filter (3).
Install gasket (20), filter bowl (19),
and securing plate (18) and secure to
fuel filter (3) with four screws (15).
Install brace (10) on fuel filter (3) and
secure with two screws (21),
lockwashers (17), and nuts (16).
INSTALLATION
1. Install large nipple (4) in filter (3)
inlet side and small nipple (2) in fuel
filter (3) outlet side.
1. Position fuel filter (3) on water heater
brace (8) and secure with two screws
(7), flat washers (6), lockwashers (8),
and nuts (9).
3. Connect hose (5) to large nipple (4).
4. Connect hose (1) to small nipple (2).
NOTE
If bowl and gasket were replaced,
ensure there are no fuel leaks.
5. Perform follow-on installation.
Install tarp assembly
(TM 10-3510-220-10).
2-170
