TM 10-3510-220-24
2-53.
WATER PUMP AND MOTOR ASSEMBLY (CONT)
REPAIR (Cont)
NOTE
The water pump and motor is an integral part of the water pump
assembly, making it necessary to replace both assemblies if a defect
occurs to either assembly.
4. Repair water pump and motor.
a .
b .
c.
d .
e .
f.
g.
h.
i.
j.
Disconnect wires in motor power junction
box (refer to REPAIR paragraph 3).
Disconnect conduit at motor power junction
box (refer to REPAIR paragraph 3).
Remove inlet water strainer (refer to
SERVICE).
Remove water outlet assembly (refer to
REPAIR).
Remove four nuts (42), lockwashers (41),
flat washers (40), and screws (39). Remove
water pump assembly (38) from frame (37).
Position water pump assembly (38) on frame (37) and secure with four screws (39), flat
washers (40), lockwashers (41), and nuts (42).
Install water outlet assembly (refer to REPAIR paragraph 1).
Install inlet water strainer (refer to SERVICE).
Connect conduit to motor power junction box (refer to REPAIR paragraph 3).
Connect wires in motor power junction box (refer to REPAIR paragraph 3).
2-193
