TM 10-3510-220-24
3-16. EXTRACTOR DRIVE UNIT (CONT)
ADJUSTMENT (Cont)
2.
3.
4.
5.
6.
7.
8.
9.
NOTE
You should be able to pull/push the top of the drive shaft
approximately 1/2 inch (12. 7 mm) off center. If movement is less than
1/2 inch (12.7 mm), add a flat washer under the trunnion caps. If
movement is more than 1/2 inch (12.7 mm), remove flat washer from
under the trunnion caps.
Lubricate brake mechanism and gyro ball. Refer to LO 10-3510-220-12.
Connect three brake solenoid wires (1) to brake solenoid (2). Remove tags.
Refer to paragraph 3-16 REPAIR, step 1, and install curb on base.
WARNING
Components of the extractor are heavy and maybe awkward to
handle. Use correct lifting procedures, lifting devices, and/or
assistance from other personnel to avoid injury.
Refer to paragraph 3-16 REPAIR, step 1m, and install extractor basket.
Connect extractor drain line. Refer to LO 10-3510-220-12.
Place extractor circuit breaker on electrical panel to ON position.
Operate extractor to test. Refer to TM 10-3510-220-10.
Perform follow-on installation.
Install tarp assembly (TM 10-3510-220-10.)
3-71
