TM 10-3510-220-24
3-17. EXTRACTOR CONTROL BOX(CONT)
ADJUSTMENT (Cont)
b.
Remove twelve screws (1), lockwashers (2), and extractor control panel cover (3).
c.
Ensure lid (6) is closed.
d.
Loosen two solenoid screws (11) and slide solenoid safety switch (12) upward. A small
amount of adjustment is necessary to prevent sliding the switch upward too far and
damaging the lid solenoid.
e.
Tighten safety switch screws
(11).
WARNING
High voltage is present on this equipment.
Use extreme caution while power is on
and control box components are exposed.
f.
g.
h.
i.
j.
Connect power to the extractor.
Start the extractor. Refer to
TM 10-3510-220-10.
[f the extractor motor fails to run,
repeat steps d thru g above.
Turn off extractor.
Install extractor control panel cover
(3), twelve lockwashers (2), and
screws (1).
3-75