TM 10-3510-220-24
3-17.
EXTRACTOR CONTROL BOX (CONT)
ADJUSTMENT (Cont)
d.
Adjust lid hinge brake adjusting bolt (4), located on the center of hinge brake (5), for
proper lid tension.
e.
Install extractor control panel cover (3), twelve lockwashers (2), and screws (1).
WARNING
High voltage is present on this equipment.
Do not perform maintenance with power
on. Death or serious injury may result.
WARNING
Failure to properly adjust the lid safety
switch could result in injury to personnel.
2.
Adjust lid safety switch (9).
a.
b.
c.
d.
e.
Set extractor circuit breaker on
electrical panel to the OFF position.
Remove twelve screws (1), lock-
washers (2), and extractor control
panel cover (3) from rear of unit.
Ensure lid (6) is closed.
Use allen wrench and loosen lid
safety cam screw (7).
Rotate lid safety cam (8) until lid
safety switch (9) is pressed.
3-73
