TM 10--3510--221--24
0141 00--1
FRONT SIDE--TO--SIDE VIBRATION ELIMINATOR
REPLACEMENT
0141 00
THIS WORK PACKAGE COVERS:
Removal, Installation
INITIAL SETUP:
Maintenance Level
Materials/Parts
Unit
Tools and Special Tools
Equipment Conditions
Tool Kit, General Mechanics (Item 1, WP 0272 00)
LADS power shut off at main control
enclosure (WP 0112 00).
REMOVAL
WARNING
Keep hands and feet clear of drums when venting air bags. Failure to follow this precaution
could result in severe personnel injury.
NOTE
In order to maintain optimum drum balancing performance front vibration eliminators should
be replaced in pairs.
1. Vent air pressure from air bags (1) as follows:
a. Disengage two latches (2), then open access door (3).
b. Close manual valve (4).
c. Open petcock (5).
d. Open petcocks (6) on front air bags (1).
e. Allow air pressure to vent from air bags (1) then close petcocks (5 and 6).
NOTE
Step 2 applies to right front vibration eliminator on drum B only.
2. Remove eight screws (7), flat washers (8), and nuts (9), then remove access panel (10) from flat rack (11).
3. Loosen, but do not remove four screws (12), securing nut plate (13) and pre--load plate (14) to drum frame
(15).
4. Pull vibration eliminator (16) from between pre--load plate (14) and bumper support (17).
