TM 10--3510--221--24
0142 00--1
REAR SIDE--TO--SIDE VIBRATION ELIMINATOR
REPLACEMENT
0142 00
THIS WORK PACKAGE COVERS:
Removal, Installation
INITIAL SETUP:
Maintenance Level
Materials/Parts
Unit
Washer, Lock (Item 30, WP 0275 00)
Tools and Special Tools
Equipment Conditions
Tool Kit, General Mechanics (Item 1, WP 0272 00)
LADS power shut off at main control
enclosure (WP 0112 00).
REMOVAL
NOTE
In order to maintain optimum drum balancing performance rear vibration eliminator should be replaced in pairs.
WARNING
Keep hands and feet clear of drums when venting air bags. Failure to follow this precaution
could result in severe personnel injury.
1. Vent air pressure from air bags (1) as follows:
a. Disengage two latches (2), then open access door (3).
b. Close manual valve (4).
c. Open petcock (5).
d. Open petcocks (6) on front air bags (1).
e. Allow air pressure to vent from air bags (1) then close petcocks (5 and 6).
2. Remove four screws (7) and lock washers (8) securing nut plate (9) to pedestal (10).
3. Remove nut plate (9) and vibration eliminator (11) from pedestal (10).
