TM 10--3510--221--24
0142 00--2
REAR SIDE--TO--SIDE VIBRATION ELIMINATOR
REPLACEMENT -- Continued
0142 00
1
6
2
3
4
5
10
11
9
87
12
INSTALLATION
1. Install new vibration eliminator (11) onto nut plate (9). Ensure inner hole on vibration eliminator is centered
over pin (12).
NOTE
When compressing vibration eliminator ensure end remains square against nut plate.
2. Mate nut plate (9) with pedestal (10).
3. Install four screws (7) and lock washers (8) to secure nut plate (9). Tighten screws in a criss--cross manner.
4. Open manual valve (4).
5. Close access door (3) and secure by engaging two latches (2).
6. Perform a test laundry cycle (TM 10--3510--221--10). Verify smooth operation of drum.
END OF WORK PACKAGE