(4) Remove the water pump frame capscrew
hose, and move the coupler or adapter back.
To
(5) that holds the water pump to the baseboard.
accomplish this, proceed as follows:
(5) Remove the nuts, washers, and bolts that
(a) Place a mark around the hose about 3 inches
hold the shower stand holddown straps (6) to the
behind the leak.
baseboard, and remove the straps.
(b) Use the mark as a guide and cut the hose
(6) Remove the two screws that hold the fire
with a sharp knife, making the cut smooth and even.
extinguisher bracket (3) to the baseboard, and remove the
(c) Remove the coupler with gasket or the
bracket.
adapter and the clamps from the damaged length of hose
((1) above).
d. Inspection.
(d) Install the coupler with gasket or the adapter
(1) Inspect for torn, deteriorated, and frayed
and the clamp on the serviceable length of hose ((1)
shower stand holddown straps (6), and check the straps
above).
for broken or missing buckles.
(2) Inspect for bent or damaged retaining straps
4-17. Baseboard
(2 and 4).
(3) Inspect for bent or damaged fire
extinguisher bracket (3).
(4) Inspect for cracked and broken baseboard
support the entire bath unit during transit and storage. The
and check for any gouged-out portions in the baseboard.
retaining straps (2 and 4) are used to hold the water heater,
Inspect the baseboard for any indication of warping or
water pump and shower stands to the baseboard during
separating of the plies. Make certain the paint is not
transit and storage.
flaking or peeling on the baseboard.
b. Servicing and Repair. For service information,
(5) Inspect for damaged or stripped threads on
refer to paragraph 3-8. For repair information, refer to
the bolts, nuts, and capscrews.
e. Installation. Replace defective baseboard and
c. Removal.
straps with serviceable ones, an e install them by
(1) Refer to paragraph 2-2 b and remove all bath
reversing the procedure in c above.
Use the old
unit equipment from the baseboard.
baseboard as a template for drilling of the replacement
(2) Remove the capscrews that hold the water
baseboard.
heater skid retaining straps (2) to the baseboard (7), and
remove the straps.
(3) Remove the nuts, washers, and bolts that
hold the water pump frame retaining straps (4) to the
baseboard, and remove the straps.
4-10
