TM 10-7360-226-13&P
0017 00
CONTAINERIZED KITCHEN (WITH TRAILER)
UNIT MAINTENANCE PROCEDURES
2. The CK is completely closed or in the nearly closed position. The CK is nearly closed
when the wing is supported in place by only a safety strap; it is completely closed when
the wing is fastened shut by the cam locks. In either the nearly closed or completely
closed position, each item inside the kitchen is positioned in its pack out location.
_________
WARNING
If the CK is in the nearly closed position, use cargo straps, in addition to safety
straps, to secure the CK wing on the damaged/broken winch side.
The CK setup procedure is different depending on which of the following two CK winch
assemblies fail:
a) Winch assembly failure occurs on the preparation side of the CK. The normal CK
setup procedures should be followed resulting in the serving line side of the shelter
being lowered and jacks positioned in place. Next, the refrigerators should be
moved to the serving line side of the kitchen. After the refrigerators have been
moved, there should be enough space to allow for access to the winch assembly
access panel. The Winch Removal/Replacement procedures can be implemented.
b) Winch assembly failure occurs on the serving line side of the CK. The set-up
procedure of the kitchen must be done out of sequence. The serving line wing of the
CK must be secured in place by use of either the cam locks or combination of safety
and cargo straps. The preparation side wing of the CK must be lowered and
supported by jacks. The refrigerators must be carefully moved into the preparation
side wing of the CK. Care must be taken not to tear the fabric wall while moving the
refrigeration units. Once the refrigerators are moved, the Winch Removal/
Replacement procedures can be implemented.
3. The CK is in an intermediate wing position and gravity has caused the wing to fall down
past horizontal (this is not a catastrophic failure of the CK). A forklift may be needed to
carefully lift the wing up so that jacks can be installed to support the wing.
NOTE
Use care when positioning the fork prongs under the wing as to not cause damage.
With the wing supported, normal CK setup procedures should be completed and the
winch assembly replaced.
Winch Removal/Replacement Procedures:
Winch Removal:
1. Before removing the winch, make sure the wing of the Containerized Kitchen (CK) is
supported either by jacks or safety straps.
Change 2
0017 00-6
