2-44. DRYER TUMBLER ASSEMBLY (CONT)
REPAIR (Cont)
l.
m.
n.
o.
p.
q.
Pull wires (54) through conduit (59) and install conduit in solenoid (69).
Install solenoid (69) on bracket (62) and secure with two mounting screws (63) and
lockwashers (65).
Connect wires (54) to terminals in junction box (55).
Install cover (56) on junction box (55) and tighten with six screws (57).
Connect two fuel lines (60)
to nipples (61).
Open fuel shutoff valve (64).
4. Repair dryer door assembly.
NOTE
Repair door assembly by replacing the
unserviceable door with a new one.
a. Open dryer door (73).
b. Remove pin (74) from center of
door hinge (75).
CAUTION
Support the door while removing the
hinge rod.
c.
d.
e.
f.
Drive hinge rod (72) down through
door hinge (75).
If hinge rod (72) is being
replaced, loosen setscrew (76) and
remove door switch cam (77) from
the bottom of the hinge rod and
install it on the new hinge rod.
Position new dryer door (73) on the
dryer, align door hinge (75), and
drive hinge rod (72) into the hinge from the bottom.
Install pin (74) into center of door hinge (75).
2-159
