TM 10--3510--221--10
0018 00--4
WASHING/DRYING SYSTEM TROUBLESHOOTING --
Continued
0018 00
DRUM MOTOR STALLS DURING EXTRACT
1.
Use MENU SELECTION switch (WP 0008 00, Figure 2, 7) to select PAUSE.
2.
At operator panel where cycle was paused press MENU SELECTION switch (7) to CONTINUE
CYCLE.
Does another drum motor stall occur?
YES Go to step 3.
NO Return to normal operation.
3.
Check for debris in water pump strainer (WP 0028 00).
Is strainer clean?
YES Go to step 4.
NO Clean and replace strainer. Return to normal operation.
4.
Check for presence of standing water inside drum.
Is standing water visible through window in drum door?
YES Go to WATER NOT DRAINING FROM DRUM FAULT.
NO Go to step 5.
5.
Check voltage and frequency output from power source.
Is voltage and frequency set to correct levels?
YES Notify Maintenance.
NO Correct external power source output voltage and/or frequency as necessary.
DRYER A or B INLET TEMP HI/LO or LAUNDRY NOT DRYING
1.
Use MENU SELECTION switch (WP 0008 00, Figure 2, 7) to select PAUSE.
2.
Remove and inspect lint filter (WP 0027 00).
Is lint filter clean?
YES Go to step 3.
NO Clean and reinstall lint filter. Return to normal operation.
3.
Check cleanliness of dryer inlet screen (WP 0025 00).
Is dryer inlet screen clean?
YES Go to step 4.
NO Clean and reinstall dryer inlet screen. Return to normal operation.
4.
Check dryer outlet guard for debris (WP 0026 00).
Is dryer outlet guard clear?
YES Go to step 5.
NO Remove debris from dryer outlet guard. Return to normal operation.
